1 AiM User Guide Kit for EVO4, Solo and SoloDL on Ducati 899,1199 Panigale Release 1.01
9 The image here on the right shows the cable reaching SoloDL. Connect the cable to SoloDL as here on the right.
10 4 Configuring with Race Studio 2 Before connecting EVO4/SoloDL to the ECU it is necessary to set it via Race Studio 2 software. 4.1 Configuring S
11 The software shows SoloDL configuration page: press “Configuration Manager” and select the configuration you want to use or press “New” to create
12 Confirm pressing “OK” in both panels and transmit the configuration to SoloDL pressing “Transmit” as shown below. 4.2 Configuring EVO4 Run the s
13 The software shows EVO4 configuration page: select the configuration you want to use or press “New” to create a new one. In this second case “New
14 5 Ducati protocols Channels received by SoloDL and EVO4 connected to Ducati Panigale protocol are: ID CHANNEL NAME FUNCTION ECU_1 ECU_RPM RPM E
15 ECU_25 ECU_DIAG_V Vertical cylinder lambda diagnosis ECU_26 ECU_BRK_FRONT Front brake pressure ECU_27 ECU_BRK_REAR Rear brake pressure ECU_28
1 1 Models and years This user guide explains how to install AiM Solo and SoloDL on Ducati Panigale bikes and how to connect EVO4 and SoloDL to the
2 2.1 Kit and bracket for Solo/SoloDL on Ducati Panigale Solo/SoloDL installation kit is shown here below; part number is: V02569170CSP. The kit inc
3 2.2 AiM cable for SoloDL AiM cable for SoloDL on Ducati bikes is shown below; its part number is: V02569170. The image here below shows the cable
4 2.3 AiM cable for EVO4 AiM cable for EVO4 on Ducati bikes is shown below; its part number is: V02563150. The image here below shows the cable cons
5 3 Installation and connection Here you find the instructions to install Solo and SoloDL on Ducati Panigale and to connect EVO4 and SoloDL to the b
6 Insert the assembled brackets in the handle bar hole. Tighten the M8 screw and the distance piece until the assembled brackets about the bike fork
7 3.2 Connection of SoloDL and EVO4 to the bike ECU To connect EVO4 and SoloDL to the ECU of the bike use the connector you find under the passenger
8 Connect AiM wiring to Ducati wiring as here on the right. Take the cable to the logger as here on the right. To reach SoloDL make the cable pass b
Kommentare zu diesen Handbüchern